Bleeding Abs Brakes Chevy Silverado. The antilock brake system or abs require a primary and secondary bleeding to remove all air from the system. How to bleed abs module without scan tool.
Bleeding Abs Brake Systems from www.aa1car.com
How does the abs work on a chevy silverado? Then you need to depress the brake pedal. Pressurize the system to 35 pounds per square inch with the bleeder screws closed.
The Old Fluid Needs To Be.
Another end will go into a small bottle filled with one or two inches of fresh brake fluid. About brakes silverado chevy abs bleeding. Apply pressure by pressing the brakes and then releasing it again.
Fill The Master Cylinder, Then Have An Assitant Pump Up The Brake Pedal.
The antilock brake system or abs require a primary and secondary bleeding to remove all air from the system. Air trapped in the lines, calipers or. The scan tool will then energize and cycle the abs solenoids in the bpmv for one minute.
Do Not Release The Brake Pedal Until You Have Closed The Bleeder Valve Again.
4.select the “automatic bleed procedure” on the scan tool. Bleeding the brakes after brake components have been replaced is a step you don't want to skip if you want a firm brake pedal. Step 1 attach a pressure bleeder to the master cylinder reservoir and turn the ignition key to the on position.
You Can Skip This Step If Your Brake Fluid Looks Good And You're.
4.select the “automatic bleed procedure” on the scan tool. To do this, you need to turn on the engine or at least in a position where the battery is about to activate the abs. Fill your sprayer with two to three quarts of clean brake fluid.
How To Bleed Brakes On 1500 1999 Silverado In Order To Do This.
Jack up the car on tire at a time. Pressurize the system to 35 pounds per square inch with the bleeder screws closed. Step 2 connect the scan tool and set it to automatic bleed procedure. wait one minute for the tool to energize and cycle the abs solenoids.
Post a Comment for "Bleeding Abs Brakes Chevy Silverado"